top of page

Follow these links to download or access software that is used for pairing and updating button layouts.  Note that for DC and GC it is required to use these rather than the public domain.

image.png

Reset/Pairing Button Behavior

​

  1. While BlueRetro on and system on (note that GameCube will reset)

    1. Button press under < 3 sec (All LEDs solid): If in pairing mode will stop pairing mode otherwise all BT devices are disconnected.

    2. Button press between > 3 sec and < 6 sec (All LEDs blink slowly): Start pairing mode.

    3. Button press between > 6 sec and < 10 sec (All LEDs blink fast): Factory reset ESP32 to original BlueRetro firmware the device shipped with & reset configuration.

  2. System reset behavior while BlueRetro off & system off

    1. Holding system reset and then powering system put the BlueRetro in boot (download) mode. It effectively disables it for the current power session.

​

​

​

bottom of page